Simple fix to stop thread slippage at start of winding a bobbin.
Good, clear instructions from Kate at Ashford.
A nifty and simple means of twisting threads as you wind a bobbin. Very useful for weavers who do not have a spinning wheel.
One of the toughest things to get right when you are a beginner is the selvedge. You want it even, straight, without loops or dips. This advice by a master weaver might help.
Very cheap temple! Either for poor weavers OR if you weave narrow projects.
Mastering Weave Structures by Sharon Alderman.
It is an expensive book, so not to be invested in if you are not hopelessly passionate about weaving. If you are it will not only educate you extremely well, but it will also explode your mind.
Detailed article on replacing nasty string heddles with texsolv on a direct tie-up, 4-shaft Ullman loom. It's a bit of a tricky chore, but done carefully, and slowly it goes smoothly. Goes much better with a helper. The instructions are in a pdf file, because that's quicker than making a web page and I want to spend time weaving, not coding!
NOTE: A couple of months later, I added another 300 heddles to the loom. BUT, before doing that, I found a piece on the web by Vavstuga that advised cutting the top loops on all bundles before doing anything else. I tried that and things went much more smoothly and quickly.
When I got my Ullman, it was folded flat and I'd never seen a loom of any kind before. So of course I looked for help on the web. Nothing. I struggled and looked at pictures of other jack looms and managed to get it up and functioning. I am putting this page up with images that might help others. There are a number of these Ullmans around and they are great beginning looms.